Two Stage Relay Module – IOR2
£29.00 Exc. VAT
This IO module is used with DDCs to convert an analogue control output signal to a time proportional raise/lower, high/low or binary relay output.
Description
This IO module is used with DDCs to convert an analogue control output signal to a time proportional raise/lower, high/low or binary relay output.
Typically it is used to control valve and damper actuators from an analogue signal.
It is designed so that every status is clearly indicated with LEDs to facilitate operation and commissioning.
Specification
Input: 0 – 10Vdc 1mA min into 22KΩ impedance.
Output: 8Amp @230Vac (resistive)
Supply Voltage: 24Vac/dc +/- 10%
Operating Modes: Binary, Sequenced, Staged, Aux/ RL
Termination: Rising clamp for 0.5 to 2.5mm² cable.
Ambient: -10 to +40°C
Dimensions: 58(W) x 50(D)x 76(H)mm
| Weight | 0.5 kg |
|---|---|
| Dimensions | 33 × 10 × 5 cm |
You must be logged in to post a review.
MAECENAS IACULIS
Vestibulum curae torquent diam diam commodo parturient penatibus nunc dui adipiscing convallis bulum parturient suspendisse parturient a.Parturient in parturient scelerisque nibh lectus quam a natoque adipiscing a vestibulum hendrerit et pharetra fames nunc natoque dui.
ADIPISCING CONVALLIS BULUM
- Vestibulum penatibus nunc dui adipiscing convallis bulum parturient suspendisse.
- Abitur parturient praesent lectus quam a natoque adipiscing a vestibulum hendre.
- Diam parturient dictumst parturient scelerisque nibh lectus.
Scelerisque adipiscing bibendum sem vestibulum et in a a a purus lectus faucibus lobortis tincidunt purus lectus nisl class eros.Condimentum a et ullamcorper dictumst mus et tristique elementum nam inceptos hac parturient scelerisque vestibulum amet elit ut volutpat.
You may also like…
Related products
10 channel alarm integrator module 24Vac/dc – IO-ALM10-24
The IO-ALM10 series of Alarm Integrators monitor up to 10 Input Channels up to 24VAC/DC per channel and provide a relay output in the event of an alarm signal appearing on any one or more inputs.
The IO-ALM10 Alarm Integrators is self-powered from the alarm input and are designed for mounting on the TS35 (35mm Slotted Din Rail) section DIN rail.
24 Channel Digital Input Multiplexer – VFC input
The IOD24 module was created and designed to provide a cost-effective and efficient way of handling a large amount of digital input into a Building Management System (BMS). 24 Digital Inputs are multiplexed to provide a single analogue output (0-10V or 4-20mA) which is compatible with most open standard BMS controllers on the market currently.
Reviews
There are no reviews yet.